Interconnections - Agilent Technologies Turbo-V 3K-G 969-8888 Notice De Mode D'emploi

Interconnections

The following paragraphs describe the Turbo-V 3K-G
interconnections.
J1 – Remote I/O
At power-on the controller goes into "Remote I/O" mode, even if it
was in "Serial" mode before power-down.
Figure 12
This connector carries all the input and output signals to remote
control the Turbo-V 3K-G.
It is a 15-pins D type connector; the available signals are detailed in
the table, the following paragraphs describe the signal characteristics
and use.
Tab. 3
PIN N.
1
2
3
4
5
6
7
8
Turbo-V 3K-G Pumping System User Manual / 87-901-011-01
SIGNAL NAME
START/STOP (+)
START/STOP (-)
INTERLOCK (+)
INTERLOCK (-)
SPEED SETTING (+)
FAULT COMMOMN
SOFT START (+)
SET POINT
Technical Information
Interconnections
INPUT/OUTPUT
IN
IN
IN
IN
IN
OUT
IN
OUT
(C)
17
ISOLATION
Optocoupled
Optocoupled
Optocoupled
Optocoupled
Optocoupled
Relay
Optocoupled
Relay
311/374