Table des Matières
Publicité
Do not install or use the pump in an environment exposed to
atmospheric agents (rain, snow, ice), dust, aggressive gases, or in
explosive environments or those with a high fire risk. During
operation, the following environmental conditions must be respected:
In the presence of magnetic fields the pump must be protected using
a ferromagnetic shield. See the appendix "Technical Information" for
detailed information.
The Turbo-V 3K-G must be connected to a primary pump (see
"Technical Information").
The Turbo-V 3K-G can be installed in any position. Fix the Turbo-V
3K-G in a stable position connecting the inlet flange of the
turbopump to a fixed counter-flange capable of withstanding a torque
of 33000 Nm around its axis.
The turbopump with ISO F inlet flange must be fixed to the vacuum
chamber by means of bolts with a strength class of 12,9
(σr = 1200 N/mm
of steel bolts and the relevant fixing torque as recommended by
Agilent.
Tab. 1
FLANGE
ISO 250 F
WARNING!
The Turbo-V 3K-G cannot be fixed by means of its base. The system can only
be fixed through its ISO 250F flange.
Turbo-V 3K-G Pumping System User Manual / 87-901-011-01
maximum pressure: 2 bar above atmospheric pressure
air temperature: from +5 °C to +35 °C
relative humidity: 0 – 95 % (non-condensing)
2
). The following table shows the necessary number
FIXING DEVICE
M10 bolts
Instructions for Use
Installation
N.
FIXING TORQUE
12
30 Nm
(C)
16
289/374
Publicité
Table des Matières
