Installation Area - Corghi Artiglio Master J Manuel D'utilisation

4. INSTALLATION AREA

Install the machine in compliance with all the applicable safety standards, includ-
ing, but not limited to, those issued by OSHA.
RISK OF EXPLOSION OR FIRE. Do not use the machine in areas that could be ex-
posed to inflammable vapours (petrol, paint solvents, etc.).
Do not install the machine in a narrow area or below floor level
IMPORTANT: for the correct and safe operation of the machine, the lighting level in the
place of use should be at least 300 lux.
Do not install the machine outdoors. It is designed to be used in closed, covered areas.
Install the tyre changer in the chosen work
position, complying with the minimum clear-
ances shown in Fig.16
The support surface must have a load-
bearing capacity of at least 1000 kg/m
Work environment conditions
- Relative humidity 30% - 95% without con-
densation.
- Temperature 0°C ÷ 50°C.
Artiglio Master J Operator manual
WARNING
DANGER
CAUTION
.
2
1000
EN
16
115