Air Pressure; Additional Rim/Tyre Information; Intended Machine Use - Corghi Artiglio Master J Manuel D'utilisation

1.2.e. AIR PRESSURE
The machine is equipped with an internal pressure limiting valve to minimize the risk
of overinflating the tyre.
1. Never exceed the following pressure limits:
• The supply circuit pressure (from the compressor) is 220 psi (15 bar).
• The operating pressure (indicated on the regulator) is 150 psi (10 bar).
• The tyre inflation pressure (displayed on the pressure gauge) must never exceed the
pressure indicated by the manufacturer on the sidewall of the tyre itself.
2. Activate the air inflation jets only when inserting the bead.
3. Discharge the air pressure system before disconnecting the power supply or other
pneumatic components. The air is stored in a tank for operating the inflation jets.
4. Activate the air inflation jets only if the rim is correctly clamped on the tyre changer (if
required) and the tyre is completely mounted.

1.3. ADDITIONAL RIM/TYRE INFORMATION

Wheels equipped with pressure sensors and special rims or tyres could require
particular work procedures. Consult the service manuals from the manufacturer
of the wheels and tyres.

1.4. INTENDED MACHINE USE

This machine must only be used to demount and mount vehicle tyres from/on the rims, using
the provided tools. Any other use is considered inappropriate and may cause accidents.
The machine is not designed for working with motorcycle wheels.
Artiglio Master J Operator manual
• RISK OF EXPLOSION
• Do not exceed the pressure recommended by the
tyre manufacturer. Always match the tyre and rim
dimensions.
• Take care to avoid any injuries.
WARNING
DANGER
EN
107