Corghi Artiglio Master J Manuel D'utilisation page 151

Masquer les pouces Voir aussi pour Artiglio Master J:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

- Clean and lubricate the bead breaker sliding panel
(3, Fig.46):
Clean with environmentally-friendly solvents and lubri-
cate with ROLOIL SUPER LUBRICANT PTFE synthetic gel or
equivalent.
To carry out every two months.
- Check the condition of the tool car-
riage travel limit pads (4-5, Fig. 47):
No breakage or permanent deforma-
tion must be present.
Otherwise, contact technical assis-
tance.
To carry out every six months.
- Check the condition of the rubber guards on the bead
breakers (6, Fig. 48):
The guards must be present, with no breakage or permanent
deformation evident.
Otherwise, contact technical assistance.
To carry out every three months.
- Clean and lubricate the lower bead breaking unit pin (7,
Fig. 49) and the lower bead breaking unit coupling pin (8,
Fig. 49):
Clean with environmentally-friendly solvents and lubricate
with ordinary grease.
To carry out every month.
- Contact the service network to check the belts and rub-
ber pads:
Periodic check by the service network.
To carry out every 7000 wheels.
Artiglio Master J Operator manual
3
4
46
5
47
6
48
7
8
49
151
EN

Publicité

Table des Matières
loading

Table des Matières