Corghi Artiglio Master J Manuel D'utilisation page 145

To improve the operation of the tubeless tyre inflation system the line pressure must
be between 8 and 10 bar.
Continue inflating the tyre using the air hose. Frequently stop inflation and check the
pressure on the pressure gauge.
Risk of explosion. During the bead insertion phase, do not exceed the maximum pressure
indicated by the manufacturer on the sidewall of the tyre.
Once the bead has been inserted, refit the internal part of the valve and then inflate the
tyre to the pressure indicated by the vehicle manufacturer.
Operate the inflation jets only for tyre bead insertion. Do not point jets towards people.
Discharge the air from the pneumatic system before disconnecting the power supply or
other pneumatic components. The air is accumulated in the tank for operating the bead
insertion jets.
Operate the air jets only after making sure that the device is securely in position and the
rim is correctly blocked.
RISK OF EXPLOSION. Do not mount a tire and a rim that do not have the same diameter
(for example, 16.5 inch tyre and 16 inch rim).
If the tyre is excessively inflated, the air can be released
by pressing the brass manual deflation button located
below the air pressure gauge ("2" - Fig.41E)
Disconnect the air hose from the valve stem.
Artiglio Master J Operator manual
WARNING
WARNING
WARNING
WARNING
WARNING
EN
1 1
2 2
41E 41E
145