Amplification Factor Kp - Burkert 8625 Instructions De Service

7.3.6.2 Upper limit value
è Limit the upper control range using the upper limit value
NOTE
With external set-values (standard signals) the error message
E.02 appears as soon as a signal larger than 20 mA is read in.
Setting the pre-comma value of the upper limit value
Setting the post-comma value of the upper limit value

7.3.7 Amplification factor KP

è Select an amplification factor KP in the setting range between 0 and 99.99.
Setting the pre-comma value of the amplification factor
Setting the post-comma value of the amplification factor
Operating Manual No. 800 209
Increase of the pre-comma value
Proceed to set the post-comma
value
Increase of the post-comma value
Continue from 7.3.7
Increase of the pre-comma value
Proceed to set the post-comma value
Increase of the post-comma value
Continue from 7.3.8
39