Initialisation - Burkert 8625 Instructions De Service

5

INITIALISATION

NOTE
è Connect the cable (Fig. 2)
è Put on the lid or the control unit
è Insert the temperature controller onto the proportional valve (see Page 4 for
suitable valve types)
è Screw the temperature controller tight
ATTENTION!
Changing the direction of the cable outlet
è Carefully underlay the manifold with the screwdriver blade and
lever it out (Fig. 4).
è Turn the manifold into the desired position (max. 2x 90°)
è Press the manifold into the housing until it latches in.
Fig. 4: Turning the manifold
ATTENTION!
Operating Manual No. 800 209
Work on the device should only be carried out by specialist staff
using the correct tools!
Switch off all voltages to the temperature controller before
working on it!
When screwing the temperature controller to the proportional
valve, ensure that the flat seal is properly seated!
Do not twist off the cable ends!
29