Programming Mode - Burkert 8625 Instructions De Service

7.3

Programming mode

NOTE As only the control unit is in the Programming mode, the temperature
controller continues to work with the old values until the Programming
mode is exited.
è Hold down this key for 2 seconds.
The control unit is now in the programming mode.
Each position can be individually adjusted in the sequence of
chapters 7.3.2 to 7.3.9.
è Change the currently-adjusted value (blinks).
è Move to the next position.
è Exit the programming mode after reaching the last value:
You will return to the Standard mode.
NOTE When you leave the Programming mode, the currently-set values will
be saved, and a Reset carried out.
Attention: any current control function will be interrupted!
34 Type 8625