Operation Without The Type 8625-B Control Unit; Operation With The Type 8625-B Control Unit - Burkert 8625 Instructions De Service

6 OPERATION WITHOUT THE TYPE 8625-B CONTROL
UNIT
After switching on the operational voltage, the controller works with the preset
parameters (Page 27).
NOTE
7

OPERATION WITH THE TYPE 8625-B CONTROL UNIT

NOTE
ATTENTION!
When operating with the control unit, four modes are possible:
• Standard mode
• Programming mode
• Manual mode
• Set-up mode
Measure:
è Switch off the supply voltage:
è Insert the Type 8625-B control all necessary data will be transferred from the
unit
è Switch on the supply voltage:
è Selected the required mode:
è Close the current mode:
30
Changing the parameters or re-configuring the inputs is only
possible with the Type 8625-B control unit.
You can install the Type 8625-B control unit onto the Type 8625
compact temperature controller in place of the lid, turned by
180°.
When installing the Type 8625-B control unit, the supply
voltage must be switched off, as otherwise a re-programming
and thereby a loss of function of the Type 8625 temperature
controller can take place.
Result:
the parameters last set will be saved.
temperature controller into the control unit,
and be stored.
the Standard mode is activated (see 7.2)
Programming, Manual or Set-up mode will be
activated (see 7.3 to 7.5)
the data that has been set up will be
transferred from the Type 8625-B control unit
to the Type 8625 temperature controller.
Type 8625