Integral Action Time Tn; Manual Mode - Burkert 8625 Instructions De Service

7.3.9 Integral action time TN

è For the integral action time TN, select a value between 0.1 and 199.99 sec.
Setting the pre-comma value of the integral action time TN
Setting the post-comma value of the integral action time TN
After setting the integral action time TN, the parameters are accepted and
the return to the standard mode takes place.
7.4

Manual mode

NOTE
è In the Standard mode, hold down both keys simultaneously to
è Increase the opening angle of the proportional valve, i.e., with
è Decrease the opening angle of the proportional valve, down to
è To exit the Manual mode, press down both keys at the same
40
In the Manual mode, there is no regulation, and the proportional
valve remains in the set position.
change to the Manual mode.
The current opening angle of the proportional valve will be
displayed in % (see 8.3).
the key held down, the valve increasingly opens up to a max. of
100%.
the minimum opening angle set in the Set-up mode(see 7.5).
time; the unit changes into the Standard mode.
Increase of the pre-comma value
Proceed to set the post-comma
value
Increase of the post-comma value
Change to standard mode
Type 8625