Final Safety Checks; Blade - Evolution Rage 3 Guide D'assemblage

www.evolutionpowertools.com

FINAL SAFETY CHECKS

Part Condition

Blade

Blade installed with the rotation arrows on the
blade matching the rotation arrows on the upper
blade guard. Outer blade flange and arbor screw
and washer correctly fitted.
Safety guards
Retractable lower blade guard fully operational.
Cutting Head Locks in upper position with
blade covered.
The Cutting head can only be lowered when
the blade guard release trigger is operated.
Assembly
Repeat the Assembly Safety Checks.
Operation
With the machine switched OFF and disconnected
from the mains supply carry out the following:
When all adjustments have been made, set the
machine at each of the maximum settings.
Lower the blade to its lowest position and
rotate the blade by hand, (it is advisable to wear
gloves whilst doing this), and ensure that the
blade does not foul on any part of the machine,
castings or guards.
Power Supply
Supply matches specification found on machine
rating plate. Plug matches power source outlet.
ALL THE YES BOXES MUST BE TICKED BEFORE THE MACHINE CAN BE USED.
ANY 'NO' = DO NOT USE. STOP, CHECK AND REASSEMBLE BEFORE PROCEEDING.
BEFORE CONNECTING TO THE MAINS POWER SUPPLY
REFER TO THE ORIGINAL INSTRUCTION MANUAL
INCLUDED WITH THIS PRODUCT FOR INSTRUCTIONS
ON HOW TO OPERATE THE SAW.
17
EN
Yes
FR
ES