Messages; Error Messages - HYDAC ELECTRONIC HNS 3000 Notice D'utilisation

HNS 3000

11 Messages

11.1 ERROR MESSAGES

If an error is detected, a corresponding error message appears which must be
acknowledged by pressing any key.
Possible error messages are as follows:
The switch points and hystereses have been set in such a way that the
E.01
resulting switch-back point is no longer within the permitted setting range.
Example:
Switching point has been set to 21.0 cm, the hysteresis to 23.0 cm.
Correct the settings.
Action:
A data error has been detected in the saved settings. Possible causes are
E.10
strong electromagnetic interference or a defective component.
Check all the settings (programming enable, switch points, switch-back
Action:
points and basic settings) and correct them if necessary. Should an error
occur frequently, please contact HYDAC Service.
A communication error was detected within the level sensor.
E.21
Confirm the error message by pressing any key. Should the error message
Action:
continue to be displayed, please contact our service department.
An internal communication error with the temperature sensor (optional) has
E.22
been detected.
Confirm the error message by pressing any key. Should the error message
Action:
continue to be displayed, please contact our service department.
Version 2018/07/06
HYDAC ELECTRONIC GMBH
Page 20
Part No. 669927