Special Procedure - Mondolfo Ferro Aquila Tornado Manuel D'utilisation

7. Check that the beads are correctly inserted in the
rim; otherwise, defl ate the tyre, break the beads as
described in the relevant section, lubricate and turn
the tyre on the rim. Repeat the mounting operation
described previously and check again.
8. Replace the internal mechanism of the valve.
9. Adjust the pressure to the rated infl ation value
by pressing the defl ation button (2, Fig. 29d).
1
2
10. Fit the cap to the valve.
29d
5.7.c. Special procedure
If the tyre does seat correctly on the wheel during
"HUMP" (H)
infl ation, due to an excessively large gap space
between the tyre and the rim, a jet of pressurised
air may be used with the jaw of the optional T.I.
accessory (quick bead insertion).
Check that both the upper and lower beads and
the rim bead seat have been suitably lubricated
with approved paste for mounting.
1. Clamp the wheel (Fig. 29a).
2. Remove the valve stem core if not already done
"double HUMP" (H2)
29e
(Fig. 29b).
3. Connect the infl ation hose to the valve stem
(Fig. 29c).
4. Pull the tyre up slightly to reduce the space
between the upper bead and the wheel rim.
5. Press the infl ation pedal and simultaneously
press the two buttons on the accessory to deliver
a blast of high pressure air via the four nozzles,
which facilitate seating of the tyre beads (Fig. 29f).
29f
If the tyre is over-infl ated, air may be released by
pressing the brass manual defl ation button located
below the air pressure gauge (2, Fig. 29d).
Disconnect the infl ation hose from the valve stem.
User manual Aquila Tornado 163