Adjusting The End Limits; Upper End Limit; Lower End Limit; Limit Setting Without Setting Cable - SOMFY J4WT Notice D'installation

3

Adjusting the end limits

Factory setting: The motor is supplied in lower end limit position with 120 rotations to the upper end
limit.
3.1

Upper end limit

• Connect the Setting Ca�le.
• Push �oth �uttons (Up & Down) at the same time for
5 seconds (if dou�le push �utton used) or press on
WT �utton of Setting Ca�le for 5 seconds.
• Motor turns �riefly in Up direction.
• Push the Up �utton.
• Motor turns, stops �riefly, then continues to turn in Up direction.
• Continue to press till reaching the desired Up position.
Quit programming mode with saving of end limit:
Press Down �utton, the upper end limit is stored.
Quit programming mode without saving of end limit:
Press shortly WT �utton.
• If the mushroom is pushed in adjustment mode, the position
shortly �elow the mushroom is stored as upper end limit.
3.2

Lower end limit

• Connect the Setting Ca�le.
• Push �oth �uttons (Up & Down) at the same time for
5 seconds (if dou�le push �utton used) or press on
WT �utton of Setting Ca�le for 5 seconds.
• Motor turns �riefly in Up direction.
• Push the Down �utton.
• Motor turns, stops �riefly, then continues to turn in Down direction.
• Continue to press till reaching the desired Down position.
Quit programming mode with saving of end limit:
Press Up �utton, the lower end limit is stored.
Quit programming mode without saving of end limit:
Press shortly WT �utton.
3.3

Limit setting without Setting Cable

• End product has to �e positioned �etween the upper and the lower end limit.
• Push �riefly the Down �utton.
• Wait 5 seconds, then push the mushroom together with the Up or Down �utton at the same time for
5 seconds.
• Motor turns �riefly in Up direction.
• Continue as descri�ed in point 3.1 or 3.2 (push the Up/Down �utton).
26
Ref. 9015577
© 2009 Somfy SAS. All rights reserved. 12/2009