Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
9) Drill the gate leaf reinforcement.
10) Mount the bracket.
11) Put the gate arm back into position.
12) Check
that
the
et on the gate is correct by manually opening the gate.
If necessary, correct the position.
6. INSTALLING THE INTEGRATED OPENING
END STOP
1) Manually open the gate to the opened position required.
2) Install
the
end
et side, flush against the shoulder of the motor arm.
Do not tighten the end stop.
3) Close the gate slightly.
7
position
of
the
α
max
stop
on
the
4) Move the end stop approximately 2 mm towards the motor arm shoul-
der.
5) Tighten the end stop with a long Allen key for greater torque when
tightening the end stop bolts (16 Nm).
A
D
6) Install the end stop covers: screw the lower cover (with holes) (22b),
holding the sha while performing this operation, then screw in the
upper cover (22a).
brack-
22a
7) Permanently secure the gate leaf bracket using the central mounting
hole.
brack-
2mm
B
E
F
2
1
22b
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.
Axovia 220B RTS
C
Publicité
Chapitres
Table des Matières
