Mondolfo Ferro TB125 Manuel D'utilisation page 49

N.B.: for wheels with a rim well, clamp the
rim so that the well is located on the outer
side (see fig. 13A).
13A
13C
13E
WARNING
Never leave your work station with the
wheel clamped on the turntable and lifted
off the ground.
- E - User Manual TB125
nglIsh
CLAMPING ALLOY RIMS
To clamp wheels with a light alloy rim, a set of
alloy rim clamps (Fig. 14) that are specially
designed to work on these rims without the risk
of damaging them is available on request.
The clamps are to be inserted (bayonet-like
13B
mounting) into the clamp support of the turn-
table as shown in figure 15.
Lock the clamp by tightening the screw B, Fig.
15 by hand.
The clamps are supplied with three different
types of plastic insert (A, Fig. 15) to be used
based on the thickness of the rim flange.
A
13D
Lock the rim as illustrated in fig. 16.
13F
B
14
15
16
49