Tubeless And Supersingle Wheels - Mondolfo Ferro TB125 Manuel D'utilisation

WARNING:
The turntable may "slip" during the vari-
ous operating phases when the rims are
clamped on the central hole (especially
with alloy wheels where the specific clamps
are used).
By using the STOP PIN accessory (Fig. 17A) this
problem can be averted, inserting it in one of
the wheel fixing holes (see Fig. 17B).
As the pin turns it rests against the clamp, pulling
the rim with it and preventing it from slipping.
To work on wheels with light alloy rims, a
gripper for alloy rims (see Fig. 18) is also
available.
50
BEAD BREAKING
1) Clamp the wheel on the turntable, as previ-
ously described, and ensure that it is deflated.
2) Move the control console to working
position C.
3) Lower the tool holder arm into its working
position until it hooks with the ratchet.
17A
Always make sure that the arm is correctly
hooked to the carriage.
4) Using the control lever R position the wheel
so that the external rim profile barely touches
the bread breaker disc (fig.19).
17B
18
The bead breaker disc must not press against
the rim but the tyre bead.
TUBELESS AND
SUPERSINGLE
WHEELS
WARNING
WARNING
- E - User Manual TB125
nglIsh
19