Mondolfo Ferro TB125 Manuel D'utilisation page 54

14) Position the platform under the wheel,
lower the turntable until the wheel rests on
the platform.
15) Move the control console to working
position B.
16) Completely close the turntable clamps,
making sure that the wheel is supported to
prevent it from falling.
WARNING
This operation can be extremely dangerous!
Perform it manually if you are absolutely cer-
tain you can maintain the wheel equilibrium
only. For heavy, large sized wheels you MUST
use a suitable lifting device.
17) Move the platform to move the wheel away
from the turntable.
18) Remove the wheel.
N.B.: If the tyre permits it, the operation de-
scribed above can be speeded up by mounting
both beads at the same time:
- Follow the steps described above in points
1-5, but instead of attaching the gripper to
just the first bead (see point 5), attach both
of them.
- Lift the rim with the tyre hooked to it and
turn it 15-20 cm anticlockwise (gripper at 10
o'clock).
54
- Follow the steps described in points 12-18 in
this paragraph.
MOUNTING WITH THE HOOK TOOL
1) Follow the steps described in points 1-6 for
mounting with the bead breaker disc.
2) Move the tool holder arm to the non-working
position; move it to the inner side of the tyre
and rehook it in this position.
3) Make sure that the hook tool is positioned
to the side of the wheel. Otherwise, press the
tool rotation lever and turn it 180°.
25
4) Move the control console to working
position D.
5) Move the tool forward so that its red refer-
ence dot is aligned with the external edge of
the rim, 5 mm. away from it (see Fig. 26).
6) Move the control console to working
position C.
7) Move to the outside of the wheel and visu-
ally check the exact position of the tool and
adjust it as needed. Then turn the turntable
clockwise until the gripper is at the lower
point (6 o'clock).
The first bead is now in the rim.
8) Remove the gripper.
- E - User Manual TB125
nglIsh
26