Cleaning; Cleaning The Outer Surfaces; Cleaning The Inner Surfaces; Removing The Wire Shelf Supports - Pelgrim OKW740RVS Mode D'emploi

CLEANING

Cleaning the outer surfaces

Cleaning the inner surfaces

Removing the wire shelf supports

EN 26
Warning
Before starting a pyrolysis cleaning cycle, make sure that any
accessories that are not pyrolysis safe have been removed from the oven
(sliding rails, baking trays, chrome-plated grills, and so on) as well as any
cookware. The side grills are pyrolysis safe and may be left inside the
oven during pyrolysis.
To clean both the electronic programmer window and the oven door, use
a window washing product applied to a soft cloth. Do not use abrasive
creams or scouring sponges.
No pyrolysis ovens
• Smooth side panel models.
Clean the still-warm oven with a cloth dipped in hot, soapy water.
• Rough side panel, self-greasing, catalytic models.
Warning
For any cleaning operation inside the oven cavity, the oven must be
switched off. Before starting to disassemble the appliance, allow it to
cool down and ensure that it has been disconnected from the power
supply.
Wire shelf supports with hooks.
To remove them, lift up the front part of the shelf support to disengage
the front hook from its housing.
Then gently pull the whole of the support towards you and lift the back to
release the rear hook from its housing.
Pull out the two shelf side supports.