USING YOUR OVEN
The timer function
Timer
MINUTERIE
The cleaning function
Cleaning
NETTOYAGE
(1)
When to use pyrolysis
EN 18
• Select this option to access the timer function.
This function is accessible, so long as the oven is not in pyrolysis
mode.
• Press the < and > buttons until 'TIMER' is displayed then confirm.
The displays flashes 00:00.
• Enter the desired time using the < or > button and confirm with the
OK button.
The timer starts to count down when OK is pressed and beeps at
the end.
• Press the Stop button to cancel the timer.
This oven is equipped with a pyrolysis cleaning function:
Pyrolysis is a cycle during which the oven cavity is heated to a very
high temperature in order to eliminate dirt caused by splashes and
spills.
Fumes and odours released are destroyed by passing through a
catalytic converter.
Pyrolysis is not necessary after each cooking cycle, but simply when
the degree of dirt warrants it; your oven will inform you when cleaning is
required via the control panel (1).
As a safety measure, cleaning only occurs after the door locks
automatically. Once the temperature inside the oven exceeds cooking
temperatures, it is not possible to open the door.
If your oven releases smoke during preheating or releases a great
deal of smoke during cooking or if there is an unpleasant odour after
cooking various dishes (lamb, fish, grills, etc.).
Note:
You should not wait until the oven is heavily coated in grease to carry
out a cleaning cycle.