GGP ITALY SPA TC 102 Série Manuel D'utilisation page 125

PROBLEM
11. The engine stops
running, and no
acoustic signal
is generated
12. The cutting means do
not engage or do not
stop promptly when
they are disengaged
13. Uneven mowing and
insufficient collection
(for rear collection
models only)
14. Uneven mowing (side
discharge models only)
15. Unusual vibrations
while working
16. Uncertain or
ineffective braking
17. Erratic forward
movement, poor drive
when going uphill or
if the machine has a
tendency to rear up
18. When the engine is
running, the machine
remains stationary
when the drive
pedal is pressed
19. Unusual machine
vibrations
If problems persist after having performed the above operations, contact your Dealer.
PROBABLE CAUSE
battery disconnected
engine problems
loose belt
problems with the electro-magnetic
clutch
cutting means assembly is
not parallel to the ground
inefficient cutting means
forward speed too high
compared to height of grass
collector chute is blocked
cutting means assembly is
not parallel to the ground
inefficient cutting means
cutting means assembly is full of grass
the cutting means are
unbalanced or loose
loose bolts and screws
the brake is not adjusted correctly
problems with the belt or the
engagement device
release lever in the gear
disengagement position
damaged or loose parts
check the connections (see 3.4)
contact your Dealer
contact your Dealer
contact your Dealer
check the tyre pressure (par. 6.1.3)
reinstate the alignment of the cutting means
assembly in relation to the ground (par. 8.2.1)
contact your Dealer
reduce the forward speed and/or raise
the cutting means assembly (par. 6.5.4)
wait for the grass to dry
remove the grass catcher bag and
empty the chute (see 5.4.7)
check the tyre pressure (par. 6.1.3)
reinstate the alignment of the cutting means
assembly in relation to the ground (par. 8.2.1)
contact your Dealer
clean the cutting means assembly (par. 7.4.4)
contact your Dealer
check and tighten all the engine and frame
bolts
contact your Dealer
contact your Dealer
return it to the gear engaged
position (par. 5.13)
stop the machine and remove
the ignition key
inspect for damage
check for and tighten any loose parts
have all checks, repair work and
replacements carried out by a
Authorised Service Centre only.
EN - 29
REMEDY