Controls For Adjusting The Height Of The Cutting Means Assembly; Cutting Means Assembly; Speed Regulator Device (Cruise Control); Counter (If Fitted) - GGP ITALY SPA TC 102 Série Manuel D'utilisation

5.12 CONTROLS FOR ADJUSTING
THE HEIGHT OF THE CUTTING
MEANS ASSEMBLY
• Control with lever
This lever is used to raise and lower the cutting
means assembly, which may be positioned
at 7 different cutting heights (fig. 15.H).
The seven positions for this lever,
shown as «1» to «7» on the label,
correspond to various cutting
heights between 3 and 9 cm.
To change positions,
press the release button
on the end of the lever.
• Control with lever and knob
This lever (fig. 15.H) is used to raise and
lower the cutting means assembly.
• Position «A»
Cutting means assembly raised.
• Position «B»
Cutting means assembly lowered.
The knob (fig. 15.I) is used to set the
cutting means assembly to one of 9
different positions, corresponding to nine
cutting heights between 2 and 10 cm.
1. Set the lever (fig. 15.H) to position «A» .
2. Adjust the cutting height using
the knob (fig. 15.I).
3. Set the lever (fig. 15.H) to position
«B» to move the cutting means
assembly automatically to a
pre-defined cutting height.
NOTE Set the lever (fig. 15.H) to position
«A» during transport and shipping.
5.13 SPEED REGULATOR DEVICE
(CRUISECONTROL)
This device is used to maintain the
forward speed at the desired value,
without having to maintain pressure
on the pedal (fig. 13.B, 14.B).
The mushroom type control
button has two positions:
1. Pressed. Device disabled
2. Pulled out. Device
• When the device is activated, the machine
maintains the same forward speed, without
having to operate the pedal (fig. 13.B, 14.B).
• The device cannot be used in reverse
mode.
• The reverse pedal is disabled when this
device is enabled (fig. 13.C, 14.C).
NOTE Speeds may vary with respect
to the selected value when the machine
is moving up or down slopes.
To deactivate the device and restore pedal
speed control (fig. 13.B, 14.B) simply:
• press the pedal (fig. 13.B, 14.B);
or
• press the brake pedal (fig. 13.A, 14.A).
In both cases, the mushroom button will return
automatically to the «Pressed» position.
IMPORTANT Never use the mushroom
button to deactivate the device.
5.14 COUNTER(IFFITTED)
The counter (fig. 15.K) is activated whenever
the key (fig. 15.A) is set to the «ON» position,
and indicates the engine operating hours.
EN - 12
(deactivated)
enabled (active)