Deleting An Unwanted Portion (Truncate) - Roland SP-404SX Mode D'emploi

Making Fine Adjustments to the Start
Point and End Point
1. Make sure that the [PATTERN SELECT] button
is extinguished . If it is lit, press the [PATTERN
SELECT] button to turn it off .
2. Play the pad whose playback region you want to
adjust, making it the current pad .
3. Press the [START/END/LEVEL] button so the
button is lit .
4. Use the [CTRL 1] knob to adjust the start point,
and the [CTRL 2] knob to adjust the end point .
5. When you've finished making adjustments, press
the [START/END/LEVEL] button to turn off its light .
Start sampling
[CTRL 1]
Start Point
This region will sound
MEMO
• You can press the pad to produce sound even while
making adjustments.
• For both the [CTRL 1] and [CTRL 2] knobs, turning the knob
toward the left will move the start point/end point toward
the beginning of the sound, and turning the knob toward
the right will move the point toward the end of the sound.
• You can't adjust the playback region beyond the begin-
ning or end of the sample.
• If you decide to cancel the adjustment, return the [CTRL
1] and [CTRL 2] knobs to the center position so that the
indication is "0. "
• The range of movement for a single operation is ap-
proximately 130 milliseconds before or after the current
start point or end point. If you want to adjust the point by
a greater amount, repeat the same procedure.
• You can't set the start point and end point closer than
approximately 100 milliseconds.
• If your adjustment results in the start point and end point
being respectively at the beginning and end of the sample,
the [MARK] button will go out.
• If the [MARK] button is extinguished (i.e., if the playback
region has not been adjusted), adjusting the sample's start
point or end point will cause the [MARK] button to light.
• When you move the start point or end point, the sample's
BPM (tempo) will automatically change accordingly.
However, there will be a small discrepancy in the BPM.
Deleting an Unwanted Portion
(Truncate)
By specifying the start/end points and then deleting the
unneeded portion (Truncate), you can make more efficient
use of memory.
Start sampling
Stop sampling
[CTRL 2]
End Point
NOTE
1. Play the pad that you want to truncate, making it
the current pad .
2. Make sure that the [MARK] button is lit (indicating
that the playback region has been adjusted) .
3. Press the [DEL] button .
4. Press the [MARK] button . The display indication
will change to "
5. Press the [DEL] button, and the truncation process
will begin . When "
display, the operation is complete .
MEMO
Unwanted
Start Point
This region will sound
This operation cannot be undone.
. "
t r C
" disappears from the
t rC
Never turn off the power before this operation has
been completed. Doing so will destroy the SD card.
Stop sampling
Unwanted
End Point
Truncate
29