Machine Operation; Fitting The Hose Guide / Breakaway Floor-Tool Feature; Breakaway Floor-Tool - Numatic TTV 678G / 300T Notice Originale

Fitting the Hose Guide
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum
is switched off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you
resume operation.
DO NOT push the vacuum hose onto the Floor-tool with the Floor-tool in the raised position.
13
24
www.numatic.co.uk

Machine Operation

Refit vacuum hose to the Floor-tool when finished.
Note:

Breakaway Floor-tool

The floor-tool design incorporates a safety
knock-off feature.
Allowing it to safely disengage from its mounting
should it become caught on an obstruction, during
forward machine movement.
To re-attach the floor-tool blade to its holder.
First loosen the retaining knobs on the floor-tool body
and slide onto the holding bracket.
Tighten retaining knobs to finger tight. (See Fig.13).