Setting The Width; Filling The Clean-Water Tank; Fill-Level Indicator - Numatic TTV 678G / 300T Notice Originale

Table des Matières

Publicité

Setting the Width Adjustment
First push the side pod in (see Fig.17), then pull the side pod adjustment lever and set it to one of
the three width-settings (see Fig.18-20) Repeat the operation on both sides.
18
650mm

Filling the Clean-water Tank

The TTV 678 is equipped with a large capacity 120 litre clean-water tank allowing,
for large areas to be covered in a single fill.
21
To fill the clean-water tank, lift the cover flap (Fig.21) to expose the filler cap.
Unscrew the filler cap (Fig.22) and fill the tank using a hose (Fig.23) or preferred method.
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
28
www.numatic.co.uk
Machine Set-Up
750mm
22

Fill-level indicator

The water level in the clean-water tank can be measured using the scale on the rear
of the machine (Fig.24).
24
19
20
850mm
23
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ttv 678Ttv678g/400tTtv678g/300t

Table des Matières