Machine Cleaning - Numatic TTV 678G / 300T Notice Originale

!
40
www.numatic.co.uk

Machine Cleaning

ALWAYS ENSURE THAT THE MACHINE IS SWITCHED
OFF PRIOR TO ANY MAINTENANCE.
A
B
C
Located in your waste-water (top) tank is a full tank switch, this stops your machine from
working once the waste-water reaches its maximum limit. Sometimes the switch gets clogged
and blocked, clean to ensure correct operation.
Remove white filter and rinse using clean-water, and refit.
IMPORTANT:
Never use the machine without the recommended filter as it may cause damage to the machine.
Remove debris basket filter and rinse using clean-water, and refit.
IMPORTANT:
If the debris basket is allowed to become clogged, vacuum performance can deteriorate.
The clean debris basket filter is located under the filler cap.
Remove debris basket filter and rinse using clean-water, and refit.
The secondary clean-water tank filter is located to the rear of the battery compartment, and
should be checked at regular intervals. Lift white plug and remove the filter, rinse and refit.
Ensure tank has been emptied and care is taken when working in the vicinity of batteries.
NOTE: ANY SPILLS SHOULD BE WIPED-UP BEFORE TANK IS LOWERED.
After use, empty waste-water tank using emptying hose
and flush-out with clean-water.
Next remove floor-tool vacuum hose and flush out
B
with clean-water.
Next empty clean-water tank, using emptying hose
and again flush out with clean-water.
C
Before removing
separator, first pull-off
connected hoses.
Whilst pressing in the
separator toggles, remove hood
and rinse using clean-water.
The hood also has a
sealing-rubber which should be
examined at every
clean-down.
!
A