Machine Set-Up; Fitting The Floor-Tool - Numatic TTV 678G / 300T Notice Originale

!
7
To fit the side pod skirts, first remove the steel retaining strip already fitted to the pod (Fig.7).
Align the steel retaining strip within the locating grooves of the rubber skirt and refit using existing screws (Fig.8)
Periodically the side skirts should be examined and checked for wear and damage. Replace as shown above.

Fitting the Floor-tool

Lower the floor-tool arm by moving the release lever to the upper position (Fig.9).
Push floor-tool onto the holder and secure with the easy-fit securing pin (Fig.10).
Push waste collection pipe onto the floor-tool; ensure a tight fit (Fig.11).
Note: Raise floor-tool again before driving to the cleaning area (Fig.12).
22
www.numatic.co.uk

Machine Set-Up

ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
9
11
8
!
10
!
12