Adjusting The Seat; Setting The Cleaning Controls - Numatic TTV 678G / 300T Notice Originale

Adjusting the Seat

32
Sitting in the driving position, adjust the seat forwards or backwards as necessary by using the lever found on the
left-hand side (see Fig.32).
Note: The seat is fitted with a pressure sensor that disables the machine until an operator is seated.

Setting the Cleaning Controls

34
www.numatic.co.uk
Machine Operation
Insert key into main control (on / off) and turn quarter-turn clockwise to position (1) 'ON'.
The battery charge level meter will illuminate.
Set automatic Chemical Dosing Mix as required, depending on floor type and level of soiling.
Set desired Brush Speed as required, depending on floor type and level of soiling.
Set Water Flow Rate as required, depending on floor type and level of soiling.