Lowering The Brush-Deck; Lowering The Floor-Tool - Numatic TTV 678G / 300T Notice Originale

Lowering the Brush Deck
28
After preparing the floor (see previous section), we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered.
While depressing left-hand foot pedal (see Fig.28), press down the release lever (see Fig.29) and gently release the foot
pedal to lower the brush deck (see Fig.30).
Note: If the brush width has not been set, see 'Setting the width adjustment' on page 28 before proceeding.

Lowering the Floor-tool

Lower the floor-tool by moving the release lever to the upper position (Fig.31).
Note: The machine will not reverse while the floor-tool is in the lowered position - 'Causes the battery indicator to flash'.
32
www.numatic.co.uk
Machine Set-Up
29
31
30