Hendi SOUS-VIDE SYSTEM Mode D'emploi page 6

2. Operation: SET TIMER (TIMER [1])
2.1 During the cooking process, the user can acti-
vate the TIMER function (TIMER [1]) by pressing
the TIMER Icon.
2.2 Upon the TIMER Icon is pressed, the TIMER Dis-
play shows either 0:00.
2.3 The user can adjust the TIMER value by the IN-
CREASE & DECREASE Icons.
2.4 When the TIMER is set, Blue LED in the TIMER
ICON is ON, emitting continuous blue light.
NOTE!
Time in count down can be adjusted all time
• During Timer is counting, if the user presses the Timer icon, Timer counting will be suspended and
shows the time left
• In this moment, the user can adjust the Timer value
• Or the user can presses the Timer icon two times, the Timer will be reset to 0:00
3. Operation: TIMER [2])
3.1 After TIMER [1] counting finished. If the user
doesn't switch OFF the TIMER or the power of the
appliance, TIMER [2] will start counting.
3.2 When TIMER [2] is counting, Blue LED in the TIMER
Icon is blinking.
EN
NOTE!
If during operation, water in the water bath has been
dry up, the thermal protection of the appliance will act
to stop the power. The TEMPERATURE Icon & TIMER
Icon will blink and alarm to alert the user. The user can
4. Switch it OFF
4.1 Switch it off by press the ON/OFF switch Icon one time
Closing the lid
After you set the time and temperature and put vacu-
umed food in the water tank, you need to close the lid.
To position the lid correctly on the tray, open the vent
valve first. Only then you can position the lid correctly.
As soon as the lid closes well, close the vent valve.
Opening the lid
To remove the lid the vent valve should be opened first,
because low air pressure under the lid will keep it in
After use
Drain the water out of the container by pressing the tap
and turn it ¼ to the left. You close the tap again by push-
6
2.5 When TIMER has been set, it will start counting
automatically
2.6 TIMER counting is in Descending order, i.e. it
counts from the SET TIME downward to ZERO
2.7 When TIMER finished counting, the appliance
beeps for 10 seconds. NOTE! When TIMER
counting finished, power of the appliance doesn't
switch OFF, the water bath will continue to oper-
ate and keep the temperature stable.
3.3 TIMER [2] starts counting in ascending order, i.e. it
starts counting from ZERO upward until the user
switches OFF the TIMER or the power of the ap-
pliance.
only switches OFF the appliance to stop this warning
signal. The user can set (or reset) Timer 1 at all time
even when Timer 2 is counting.
Put the vacuumed pouch into the water when the water
has reached the target temperature for cooking. If you
use more bags, put them in the rack and be sure that all
pouches are completely submerged.
place. Warning: steam can escape. Caution: risk of
burns.
ing it and turn it ¼ to the right. Make sure that the button
pops up slightly, this indicates the safety lock is engaged.