Hendi SOUS-VIDE SYSTEM Mode D'emploi page 5

Use
1. Operation: SET TEMPERATURE
1.1 Fill the container with (hot) water and make sure
that the water will not come over the edge on the
inner mark (groove) of the water tank. Remem-
ber that placing food in the water will also raise
the water level – it should still not pass afore-
mentioned groove. Water should be filled up to
the Max Mark no matter the amount of food you
are going to put into the water bath for cooking
1.2 Connect the power plug to Power socket
1.3 Press the ON/OFF Icon.
1.4 Then LED in the ON/OFF Icon is ON. Temper-
ature & Timer Display show 4 horizontal lines.
The appliance is in standby mode. NOTE! The
appliance beeps once for a short time
1.5 The user has to press the Temperature Icon to
activate the power. NOTE! the appliance beeps
once for a longer time
NOTE!
If you don't put water into the water bath and try to switch on the power by step 1.3 to 1.7, the thermal
protection of the appliance will act to stop the power. The TEMPERATURE Icon & TIMER Icon will blink to
alert the user. The user can only switches OFF the appliance to stop this warning signal.
1.6 Upon the Temperature Icon is pressed, the heat-
ing element is switched ON. At this moment,
The Temperature Display either shows the de-
fault SET TEMPERATURE (if it is the first time in
use) or the pervious SET TEMPERATURE. The
operation starts.
1.7 The user can adjust the SET TEMPERATURE by
the INCREASE and DECREASE Icon.
1.8 When the appliance is in operation, blue light in
the TEMPERATURE Icon is ON. The TEMPER-
ATURE Display shows the SET TEMPERATURE
and ACTUAL TEMPERATURE of the water in al-
ternate manner.
1.9 When the ACTUAL TEMPERATURE of water
reaches the SET TEMPERATURE, beep alarm
will last for 10 seconds in the following pattern.
NOTE! In this moment, the Temperature Indica-
tion lamp is ON without blinking.
EN
5