Wireless Camera - Sygonix 1594378 Mode D'emploi

b) Wireless camera
• Screw the second (shorter) antenna to the corresponding socket on the back of the camera. The antenna can be
pointed at different angles to improve reception.
• Secure the wall mount in place with suitable screws, and if necessary, dowels (depending on the mounting surface).
Ensure that you do not damage cables or wires when drilling holes or tightening screws.
Before fixing the mount in place, check that the transmission between the camera and the monitor/DVR is
functioning correctly.
Environmental factors can reduce the range and the quality of the signal. See section 20 for details.
Install the camera at least 2.5 m above the ground where it will not be susceptible to tampering.
When installing the camera outdoors, we recommend placing it in a location that is protected against rain/
spray water (e.g. under eaves), as water droplets/spray water on the front of the camera may lead to a
distorted image.
• Adjust the lens so that it points at the desired surveillance area. You can fine tune the position of the lens later when
you view the image on the monitor/DVR.
• Place the power adapter cable in a suitable cable duct (or similar device). The power-in connector is not protected
against moisture/liquids and must be placed in a dry location (e.g. in a suitable connector housing).
The control button (20) on the camera cable is used to pair the camera with the monitor/DVR. Take care
not to press this button by accident.
If you want to pass the connection cable through a wall, protect the plug from dust and dirt (e.g. using a
small plastic bag).
The mains adapter for the wireless camera is only intended for use in dry, enclosed areas. It must not get
damp or wet, as this may cause a fatal electric shock!
• Connect the power-in plug on the power adapter to the power-in socket (21) on the camera cable.
• Plug the power adapter into a standard mains socket connected to the public grid. The function LED (14) on the
front of the camera will turn red. When the monitor/DVR has detected the wireless camera and starts to receive
image/sound data from the camera, the LED will turn green. An additional LED indicator will also turn on to the right
of the power LED on the monitor/DVR.
64