Wireless Camera; Ir Remote Control; Battery Safety Information - Sygonix 1594378 Mode D'emploi

d) Wireless camera
• The camera is suitable for use in indoor and outdoor areas (IP66). However, it must never be used in or
under water, as this may destroy the interior components.
• The wireless camera must not be exposed to extreme temperatures, direct sunlight, strong vibrations or
heavy mechanical loads.
• The power-in connector is not protected against moisture/liquids and must be placed in a dry location
(e.g. in a suitable connector housing).
The mains adapter for the wireless camera is only intended for use in dry, enclosed areas. It must not get
damp or wet, as this may cause a fatal electric shock!
• Ensure that the connection cable does not get pinched, kinked or damaged by sharp edges.
• The wireless camera is not designed to replace personal supervision of children or adults who require
special assistance. It must only be used as a supervision aid.
• Mount the camera in a location where it does not point towards bright sources of light (e.g. sunlight or
spotlights). This will lead to an overexposed image and may damage the image sensor in the event of
constant exposure.
e) IR remote control
• The IR remote control must not get damp or wet.
• The IR remote control must be powered by a CR2025 battery.

7. Battery safety information

• Keep batteries out of the reach of children.
• Do not leave batteries lying around, as they constitute a choking hazard for children and pets. If swal-
lowed, consult a doctor immediately.
• When handling leaking or damaged batteries, always use suitable protective gloves to avoid burning
your skin.
• Liquids that leak from batteries are very chemically aggressive and may cause serious damage to objects
or surfaces that come into contact with them. Always store batteries in a suitable location.
• Batteries must never be short-circuited, dismantled or thrown into fire, as this may cause a fire or explo-
sion!
• Never attempt to recharge non-rechargeable batteries, as this may cause an explosion.
• Always ensure that the battery in the IR remote control is inserted in the correct polarity (observe the
plus/+ and minus/- symbols).
60