Display Symbols; Manually Starting/Stopping A Recording - Sygonix 1594378 Mode D'emploi

d) Display symbols
Symbol
V
e) Manually starting/stopping a recording
When the camera images are shown on the display (real-time/normal mode), use the "
the IR remote control to select the image you wish to record (indicated by the "V" symbol).
Press the " " button (24) to start or stop a recording. The "
camera image when video is recording.
You can also use the touchscreen to start/stop a video recording. Touch the " " symbol to access the OSD menu,
and then touch the recording symbol ("
Function
USB storage device (USB stick or USB hard drive) is connected and ready for use
SD card is inserted and ready for use
Error accessing the USB storage device or SD card
USB storage device or SD card is full
USB storage device or SD card is write-protected
UPnP is not enabled or the router firewall is blocked
Network error
Display the number of users that are connected to the network
Network is functioning properly
Displays which camera is active (for starting a recording)
Recording video
Signal strength (wireless signal from the camera)
Number of the wireless camera
Microphone on the active camera is muted
Camera is transmitting a 1080 p video signal
Camera is transmitting a 720 p video signal
", see "G" in section 10c).
" and "
" symbol will be displayed on the corresponding
" buttons (27) on
67