Display Items" Function; System Information" Function; System Upgrade" Function - Sygonix 1594378 Mode D'emploi

g) "Display Items" function
The monitor/DVR displays a range of information such as the signal strength, SD/USB status, camera number
(C1....C4) and the network status.
These small graphics may conceal important information, therefore they can be enabled/disabled as required.
Use the touchscreen (or the arrow buttons ("
the symbols you wish to display. "
When using the touchscreen, touch the corresponding symbol to enable/disable it.
The following displays/symbols are available:
• "RSSI"
• "SD/USB status"
• "Camera"
• "Network"
Touch the "
cancel/end the current setting/selection and go back to the previous display without applying any changes.
h) "System Information" function
When you access this function, the monitor/DVR displays the firmware version and other system information.
Touch the "
control to go back to the previous display.
i) "System Upgrade" function
This function updates the firmware for the monitor/DVR and wireless camera.
This requires the monitor/DVR to be connected to the Internet.
After you select this function, the monitor/DVR will search for a new firmware version and automatically download/
install the update if a new version is available.
Touch the "
go back to the previous display.
74
" and "
" will be displayed next to the corresponding symbol when the symbol is enabled.
Wireless camera signal strength (
Indicates the selected storage device (
Short description/channel number of the wireless camera (
Network status (
" symbol on the touchscreen, or press the "
" symbol on the touchscreen, or press the "
" symbol on the touchscreen, or press the "
") and the " " button (28) on the IR remote control) to select
)
)
)
" button (31) on the IR remote control to
" (28) or "
" button (31) on the IR remote control to
)
" button (31) on the IR remote