Technical Data; Function Diagram; Installation Dimensions; Manufacturer's Warranty (European Union) - Truma Saphir compact Instructions De Montage

Technical data

Determined on the basis of EN 14511 or Truma test conditions
Designation
Saphir compact, comfort air conditioning system
Dimensions (L x W x H)
560 x 400 x 290 mm
Weight
20 kg
Power supply
230 V – 240 V ~, 50 Hz
Maximum cooling power
1800 W
Starting current
15 A (150 ms)
Power consumption
2.8 A / 35 °C
Protection class:
IP X5 (when installed)
Volume flow (cold air)
max. 310 m³/h
Refrigerant
R 407C / 0.39 kg
Contains fluorinated greenhouse gases covered by the Kyoto
Protocol. Hermetically sealed.
Global warming potential (GWP)
1774
CO2 equivalent
691.9 kg
Maximum incline of vehicle during
operation
8 %
Usage limits
+16 °C to +40 °C.
– An interior air sensor prevents the compressor from operat-
ing at temperatures of less than +16 °C.
– An anti-freeze sensor prevents non-permitted ice formation
on the evaporator coil.
– A temperature switch prevents excessive current and tem-
perature at the compressor.
E24 10R-040991
Right reserved to make technical changes!

Function diagram

Supply air
intake from
Compressor
the outside
Condenser
Fan
Supply air
Throttle
outlet to the
outside-downwards
High-pressure side
Fig. 14

Installation dimensions

The dimensions are in mm.
281
KO
60
Saphir compact
Fig. 15
Manufacturer's Warranty
(European Union)
1. Scope of Manufacturer's Warranty
As the Manufacturer of the unit, Truma undertakes a warranty
towards the Consumer that covers any material and/or manu-
facturing defects of the unit.
This Warranty is applicable in EU member states as well as in
Iceland, Norway, Switzerland and Turkey. A Consumer is the
natural person who was the first one to purchase the unit from
the Manufacturer, OEM or dealer and who neither resold the
unit in a commercial or self-employed professional capacity
nor did he or she install it for a third party in such a capacity.
The Manufacturer's Warranty covers any of the aforementioned
defects that occur within 24 months upon concluding the
purchase agreement between the seller and the Consumer.
The Manufacturer or an authorised service partner undertakes
to remedy such defects through subsequent fulfilment, i.e.
at its discretion either by repairing or replacing the defective
item. Any defective parts shall become the property of the
Manufacturer or the authorised service partner. If the unit is
no longer manufactured at the time of defect notification and
if replacement delivery has been opted for, then the Manufac-
turer may deliver a similar product.
If the Manufacturer remedies a defect under its warranty com-
mitment, the term of the Warranty shall not recommence
anew with regard to the repaired or replaced parts; rather, the
Cold air
outlet
Circulated
air intake
from inside
Low-pressure side
560
195
LA
84
LE
63 15
21