Accessories; Technical Data; Function Diagram; Manufacturer's Terms Of Warranty - Truma Frostair 3200 RC Mode D'emploi

Accessories

– Noise suppressor for instal-
lation in the cold air pipe for
additional noise reduction
within the living compart-
ment (Part no. 40040-60100).
– Particle filter for cleaning
interior air (Part no. 40040-
17000)
– Underfloor installation kit
(Part no. 40090-16000).
– Alternative air supply
flexible intake pipe (Part no.
40090-18000).

Technical data

determined in accordance
with EN 814 or Truma test
conditions
Designation:
Frostair 3200 RC, Air condi-
tioner with heat pump
Area of operation:
Stationary operation in
mobile homes (statics)
Dimensions (LxWxH):
780 x 460 x 350 mm
Weight: Approx. 52 kg
Power supply:
230 V / 50 Hz
Maximum cooling
capacity: 3.2 kW
Maximum heating
capacity: 2.8 kw
Actual power
consumption: 1.5 kW
Start-up current:
45 A (300 ms)

Function diagram

Supply air infeed
from the
outside-
down-
wards
LE
Compressor
Fan
Cold/warm air outlet
Cooling Heating
Current consumption: 7 A
Protection mode: IP X4
Energy Efficiency Rate
(EER): 2.1
Volume flow (cold air):
max. 550 m³/h
Cooling agent:
R 407C
Cooling agent content:
See name plate on unit
Compressor oil:
MEL 56, 520 cm³
Operational limits:
+ 3°C to + 45°C
– An interior air sensor pre-
vents the compressor from
operating in cooling mode
at temperatures of less
than + 20°C.
– An icing sensor prevents
impermissible formation of
ice on the evaporator.
– A temperature switch pre-
vents excess current flow
and excess temperature at
the compressor.
Right to effect technical
modifications is reserved!
Supply air
discharge
outside -
LA
Fan
Four-way
valve
Throttle
Evaporator
Filter
Circulating air suction intake
from inside
Manufacturer's
terms of warranty
1. Case of warranty
The manufacturer grants a
warranty for malfunctions
in the appliance which are
based on material or produc-
tion faults. In addition to this,
the statutory warranty claims
against the seller remain
valid.
A claim under warranty shall
not pertain:
– Tor parts subject to wear
and in cases of natural
wear and tear,
– As a consequence of the
use of non-original Truma
components in the equip-
ment,
– As a consequence of failure
to respect Truma instruc-
tions for installation and
use,
– As a consequence of
improper handling,
– As a consequence of
improper transport pack-
ing, not arranged by Truma.
2. Scope of warranty
The warranty is valid for
malfunctions as stated under
item 1, which occur within
24 months after conclusion
of the purchase agreement
between the seller and the
final consumer. The manufac-
turers will make good such
defects by subsequent fulfil-
ment, i.e. at their discretion
either by repair or replace-
ment. In the event of manu-
facturers providing service
under warranty, the term
of the warranty shall not re-
commence anew with regard
to the repaired or replaced
to the
parts; rather, the old warranty
period shall continue to run.
down-
More extensive claims, in
wards
particular claims for compen-
satory damages by purchas-
ers or third parties, shall be
excluded. This does not affect
the rules of the product liabil-
ity law.
The manufacturer shall bear
the cost of employing the
Truma customer service for
the removal of a malfunction
under warranty – in particular
transportation costs, travel-
ling expenses, job and mate-
rial costs, as long as the
service is carried out in Ger-
many. The warranty does not
cover customer service work
in other countries.
Additional costs based on
complicated removal and
installation conditions of the
appliance (e.g. removal of
furniture or parts of the vehi-
cle body) do not come under
warranty.
3. Raising the case of
warranty
The manufacturer's address
is: Truma Gerätetechnik
GmbH & Co. KG, Wernher-
von-Braun Strasse 12,
85640 Putzbrunn. In Germany,
always notify the Truma
service centre if problems
are encountered; in other
countries the relevant service
partners should be contacted
(see list of addresses). Any
complaints are to be de-
scribed in detail. In addition,
the properly completed guar-
antee certificate is to be pre-
sented, or the factory number
of the unit and the date of
purchase given.
To avoid transport damage,
the device may only be dis-
patched after agreement with
the Truma Service Centre in
Germany or with the particu-
lar service partner concerned
abroad. The risk for pos-
sible transport damage will
otherwise be borne by the
consignor.
Dispatch is normally to be
carried out by freight for-
warders using the special
dispatch boxes available from
Truma. If it is a case of war-
ranty, the factory shall bear
the cost for the delivery to
the factory and the cost for
returning the appliance to the
customer. If the damage is
deemed not to be a warranty
case, the manufacturer shall
notify the customer and shall
specify repair costs which
shall not be borne by the
manufacturer; in this case,
the customer shall also bear
the shipping costs.
7