Ir Remote Handset Battery Change; Disposal; Accessories; Technical Data - Truma Saphir comfort RC Mode D'emploi / Instructions De Montage

IR remote handset battery change

Please be sure to use leak-proof micro-batteries only, type
LR 3, AM4, AAA, MN 2400 (1.5 V).
The battery compartment is located on the rear of the remote
control unit.
When fitting new batteries, ensure the polarity (positive /
negative) is correct!
Dead and used batteries may leak and damage the
remote control unit. Remove the batteries if the remote
control is not going to be used for an extended period.
No claims under guarantee will be considered for
damage caused by leaking batteries.

Disposal

Before disposing of a defective remote control, it is essential
that the batteries be removed and disposed of in a proper
manner.
The device must be disposed of in line with the administra-
tive regulations of the respective country in which it is used.
National regulations and laws (in Germany, for example, the
End-of-life Vehicle Regulation) must be observed.

Accessories

Noise suppressor for installation in the cold air pipe for addi-
tional noise reduction within the living compartment
(part no. 40040-60100).
The flexible air conditioning intake allows the air conditioning
unit to be installed in a space that is sealed off from the interi
or (e.g. false floor or rear storage space) and prevents con-
taminat ed air from being drawn in
(part no.40090-59100).
18

Technical data

Determined on the basis of EN 14511 and the Truma test
conditions.
Designation
Saphir compact, comfort air conditioner
Area of operation
Small areas, mobile and stationary
Number of units
1
Dimensions (L x W x H)
628 x 400 x 290 mm
Weight
ca. 23,5 kg
Power supply
230 V – 240 V ~, 50 Hz
Maximum cooling capacity
2,4 kW
Heating power
1,7 kW
Compressor Oil
0,98 kW
Start-up current
20 A (150 ms)
Power consumption
4,2 A
Protection mode
IP X5
Energy Efficency Rate (EER)
2,4
Volume flow (cold air)
max. 380 m³/h
Cooling agent
R 407C
Cooling agent content
see type plate on the device
Compressor Oil
Diamond MA32, 300 cm³
Noise
depending on installation situation
Maximum inclination of vehicle during operation
5° / 8 %
Operational limits
+4 °C to +43 °C
– In cooling mode, a room air sensor prevents the compres-
sor operating under +16 °C.
– An icing sensor prevents impermissible formation of ice on
the evaporator.
– A temperature switch pre vents excess current flow and
excess temperature at the compressor.
Right to effect technical modifications is reserved!
Function diagram
Supply air
infeed from
Compressor
the outside
Evaporator /
Condenser
Fan
Supply air discharge
to the outside-
Throttle
downwards
Cold / warm
air outlet
Fan
Condenser /
Evaporator
Filter
Circulating air suction
intake from inside