Aborted Welding Process; Cooling Time; Returning To The Start Of Parameter Input; Additional Information In The Welding Report - Hürner HST 300 GeoTherm+ 2.0 Manuel Utilisateur

5.8

Aborted Welding Process

The welding process has failed if a plain-text error is displayed on the
screen and the audible signal buzzes continuously. An error has to be
acknowledged by pressing the STOP/RESET key.
5.9

Cooling Time

The cooling time as given in the fitting manufacturer's instructions has
to be respected. If the bar code provided by the fitting manufacturer
contains cooling time data, it will be displayed at the end of the weld-
ing process and will be counted down to zero. This countdown can
be acknowledged and canceled at any time by the STOP/RESET key.
However, note that for that time the pipe fitting joint which is still
warm must not be subjected to an external force. No cooling time is
displayed if the fitting code does not contain any such information.

5.10 Returning to the Start of Parameter Input

After welding is finished, disconnecting the welded fitting from the
unit or pressing the STOP/RESET key will reset the unit back to the
start of entering the welding parameters.
6

Additional Information in the Welding Report

Every welding report saved to system memory, which can be down-
loaded as a PDF report file or in the DataWork format, contains a
number of welding and traceability data that the operator can decide
to enter or not to enter in the set-up menu.
6.1 Entering Preformatted and User-defined Traceability Data
All traceability data enabled in the configuration menu at "Data
Recording" (see Sect. 9) have to be entered before the welding pro-
cess. The welding unit prompts the user to enter them either before
or after entering the fitting bar code (see Display 2). Depending on
what data is entered, either its repeated input is mandatory (e. g.,
the welder ID code; see Sect. 5.2) or previously entered data can be
changed and confirmed or confirmed without changes (e. g. the com-
mission number; see Sect. 6.2).
Certain traceability data can also be accessed quickly, via a selection
screen, by pressing the ï cursor key (see Display 6), either for viewing
or for entering or changing/confirming them.
6.2

Entering or Changing the Job Number

The commission number input screen is shown by the unit before weld-
ing or accessed by the user in the quick access screen (Display 6). It can
be entered using the ï, ð, ñ, ò keys or by reading it from a bar code
using the scanner. The maximum length is 32 characters. Confirm your
input by pressing the START/SET key. The job number will be saved to
memory and will appear in the printed welding report.
7

Downloading the Reports

Interface
USB A Interface Port
for connecting USB mass storage media (such as a memory
stick)
10
EN
HÜRNER HST 300 GeoTherm + 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
*** Recording
>Welder ID Code
Enter Job No.
Enter Job No.
********************
************
****
Display 6
Display 7
Version July 2013