Publicité
•
Immediately after receiving the device, make sure that it has not been damaged in
transit, and that the packaging is not damaged. In the case of damage or missing
components, immediately notify the shipper or vendor/manufacturer providing the
code-no. and serial numbers (nameplate is on the back of the unit) and attaching
photo evidence.
•
Make sure that there are no obstacles on the path to the installation site limiting
access through doors, corridors or other communication routes.
•
NOTE: During the transport of the device, it may turn over, which might result in the
damage to the device itself or other objects or in personal injuries. During the
device's transport, use the measures appropriate for its weight. The device should
not be pulled or tipped, but lifted perpendicularly to the floor and moved horizontally.
5.1.2 Installation place
•
The device must be installed in closed and well ventilated rooms (not outdoor).
•
Check the dimensions and the exact position of connections for electricity, water and
extractor connections before installation of the combi steamer.
•
We recommend to install the device under an extractor or to ensure the discharge
outside the hot vapours and odours which emerge from the cooking space.
•
The devicemust be installed on a flat surface in order to prevent it from slipping or
tipping.
•
The installation surface of the combi steamer must be suitable for the weight of the
device at maximum load.
•
Place the device unit on a firm, dry, water-resistant and heat-resistant surface.
The installation surface must be well accessible and big enough to be able to
operate freely with the device and to ensure good air circulation.
•
Install the device in such manner that the rear part is easily accessible in order to
allow the electricity and water connections and maintenance.
•
Never place the device directly against walls, kitchen furniture or other flammable
objects. Proceed according to relevant fire safety regulations.
•
Keep a minimum of 100 mm between the device and walls/other objects on the left
and right sides and at the rear, and 150 mm from the top.
•
The device is not designed to be built-in!
- 60 -
Publicité
