Publicité
EN-54
Note: The I/O's setup will only work when the I/O Option board has been installed. See the Accessory
list in section 9.2 for information. The option I/O board provides two isolated inputs and four dry-contact
normally open relay outputs which can be used for simple process weighing.
Press the button
Menu.
With the button corresponding to the icon
go down the list and highlight Application
Mode. Enter this sub-menu by pressing the
Softkey corresponding to the icon
In the Application Mode menu enter the sub-
menu Dynamic.
Select the list item and press the Softkey
corresponding to the icon
the setting as desired. After completion of I/O
Setup, press the Softkey corresponding to the
icon
screen.
4.6 Filling
Use this application to fill a container to a pre-determined target weight.
Press the button
corresponding to Filling is displayed in the
upper left portion of the home screen.
Establish the four target weights SP1, SP2,
SP3 and SP4 according to section 4.5.1.
Then place a container on the pan, perform
tare and fill the container until all the four
target weights are reached.
4.6.1 Establishing target weights
Press the Softkey corresponding to the icon
target weight
Press the Softkey corresponding to the icon
to input SP1's value. Input through the
numeric keyboard and then press the icon
to confirm.
Find Quality Products Online at:
to enter the Main
icon to change
to return to the main application
until the icon
to enter the sub-menu for setting the
.
GlobalTestSupply
www.
,
.
Defender 5000 Indicators
.com
sales@GlobalTestSupply.com
Publicité
