Publicité
Defender 5000 Indicators
4.2.4 Input/Output (I/O) Setup
The I/O's setup can be customized for various user preferences.
The I/O's setup is defined below (defaults in Bold).
Item
Enable
Discrete Input 1
Discrete Input 2
Discrete Output 1
Discrete Output 2
Discrete Output 3
Discrete Output 4
Note: The I/O's will only work when the I/O Option Board has been installed. The option I/O board
provides two isolated inputs and four dry-contact normally open relay outputs which can be used for
simple process weighing.
Press the button
With the button corresponding to the icon
down the list and highlight Application Mode.
Enter this sub-menu by pressing the button
corresponding to the icon
In the Application Mode menu enter the
Counting sub-menu.
Select the list item and press the button
corresponding to the icon
setting as desired. After completion of I/O's
setup, press the Softkey corresponding to the
icon
screen.
4.3 Check
Check is used to compare the weight or pieces of a sample against target limits.
Press the button
Two different modes can be selected in the Check Mode: Weighing, Counting.
Setup check limits according to section 4.3.1 or 4.3.2. Place object on the pan to check if the weight
is within the limits.
4.3.1 Check Weighing (default)
Make sure that the Check mode is set to Check
Weighing in the configuration menu.
Place objects on the pan. The Under/Accept/Over
status is shown in the progress bar area while the
actual weight of the item is shown on the main
Display Line.
Find Quality Products Online at:
Available Settings
On, Off
Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Off, Overload, Underload, Zero
Off, Overload, Underload, Zero
Off, Overload, Underload, Zero
Off, Overload, Underload, Zero
to enter the Main Menu.
.
to change the
to return to the main application
until the icon corresponding to Check is displayed in the screen.
GlobalTestSupply
www.
, go
.com
EN-43
sales@GlobalTestSupply.com
Publicité
