Publicité
Defender 5000 Indicators
3.9.1.1 Baud Rate
Set the baud rate (bits per second).
300
600
1200
2400
4800
9600
19200
3.9.1.2 Parity
Set the data bits and parity.
3.9.1.3 Stop Bits
Set the stop bits.
3.9.1.4 Handshake
Set the flow control method.
3.9.1.5 Alternate Print Command
Set the alternate command character for Print.
Settings of A(a) to Z(z) are available. The default setting is P.
3.9.1.6 Alternate Tare Command
Set the alternate command character for Tare.
Settings of A(a) to Z(z) are available. The default setting is T.
3.9.1.7 Alternate Zero Command
Set the alternate command character for Zero.
Settings of A(a) to Z(z) are available. The default setting is Z.
3.9.1.8 Reset
Reset the settings to factory default.
3.9.2 Print Setup of RS232/2nd RS232
3.9.2.1 Demand
If Demand is selected, the sub-menu Stable Only will display.
Set the printing criteria.
Note: For more detailed information, please refer to Section 5.3 Printout.
3.9.2.2 Auto On Stable
If Auto On Stable is selected, the sub-menu Mode will display.
Set the printing mode.
Find Quality Products Online at:
7 EVEN = 7 data bits, even parity
7 ODD = 7 data bits, odd parity
7 NONE = 7 data bits, no parity
8 NONE = 8 data bits, no parity
1 BIT
2 BIT
NONE
= no handshaking
XON/XOFF
= XON/XOFF handshaking
HARDWARE
= hardware handshaking (COM1 menu only)
OFF = values are printed immediately, regardless of stability.
ON = values are printed only when the stability criteria are met.
Load
= Prints when the displayed load is stable.
Load and Zero = Prints when the displayed load and zero reading is stable.
GlobalTestSupply
www.
EN-31
.com
sales@GlobalTestSupply.com
Publicité
