Publicité
11. Ensure both CLICKTIGHT
release buttons are
visible.
NOTE: If it is difficult to
close, you may have locked
your vehicle seat belt or
removed too much slack.
12. Connect the top tether
hook to the vehicle's top
tether anchor (check the
vehicle owner's manual
for location).
13. Pull the loose tether
strap end to remove
slack and secure excess
webbing with the elastic
band attached.
9 Both red CLICKTIGHT release buttons are visible after
installation.
9 All connections are secure and vehicle belt is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be
parallel to vehicle seat.
9 Recline indicator is still within the correct section for
FORWARD-facing, after child is secured.
9 Child restraint cannot be moved front to back or side to
side more than 2.5 cm (1 in.) at the belt path.
9 Both vehicle lap and shoulder belts are routed through the
CLICKTIGHT.
9 Excess top tether webbing is contained within your vehicle
and secured.
9 The anti-rebound bar MUST be removed.
9 The lower infant insert and upper body support pillow
must be removed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
27
Publicité
