Publicité
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Vehicle belt is locked as directed by your vehicle owner's manual.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing after
child is secured.
9 Child restraint cannot be moved front to back or side to side more than
2.5 cm (1 in.) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
9 Anti-rebound bar installed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
FORWARD-Facing Installation Harness Mode
Britax strongly recommends children should ride REAR-facing
until they exceed the weight or height limits specified.
IMPORTANT:
installing the child restraint FORWARD-facing. Using the
top tether will improve the stability of your child restraint
and reduce the risk of injury.
Use FORWARD-facing only:
• with harness straps in closest position above the child's
shoulder, and
• with children weighing 10 - 30 kg
(22 - 65 lb.), and
• who are 125 cm (49 in) or less in
height, and
• when the top of the ears are
below the top of headrest.
IMPORTANT:
MUST be removed FORWARD-
facing.
IMPORTANT:
upper body support pillow FORWARD-facing.
Installation with Vehicle Lap-Shoulder Belt (Preferred Method)
1. Extend the top tether strap
by lifting on the top tether
adjuster.
The top tether be used at ALL times when
Anti-rebound bar
Do not use the lower infant insert and/or
25
Publicité
