Publicité
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and strap is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing, after
child is secured.
9 Child restraint cannot be moved front to back or side to side more than
2.5 cm (1 in.) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
9 Anti-rebound bar installed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
Installation with Vehicle Lap Belt Only
1. Place child restraint REAR-
facing on the vehicle seat
so that the car seat base is
flat on the vehicle seat and
is parallel to vehicle seat.
2. Recline child restraint to the
appropriate position. Refer
to page 15 to determine
appropriate recline position.
3. Ensure that no more than
7.5 cm (3 in) of the base
hangs over front edge of
the vehicle seat.
4. Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
7.5 cm
7.5 cm
23
Publicité
