Publicité
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing, after
child is secured.
9 Child restraint cannot be moved front to back or side to side more than
2.5 cm (1 in.) at the belt path.
9 Both vehicle lap and shoulder belts are routed through the CLICKTIGHT.
9 Excess top tether webbing is contained within your vehicle and secured.
9 Anti-rebound bar installed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
Installation with LUAS
Do not install by this method for a child weighing more than
13.5 kg (30 lb).
1. Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
2. For models WITH
storage pouch only:
Open the storage pouch.
Remove the lower
connectors by pressing
the spring tab, pushing
the connector back while
rotating down and forward
off the anchor point.
3. Extend lower connector
strap to its longest
length by pressing grey
button on the lower
connector adjuster.
4. Place the child restraint
REAR-facing on vehicle
seat so that the car seat
base is flat on the vehicle
seat and is parallel to
vehicle seat.
5. Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
With storage
storage pouch
pouch
(Select Models)
Without
21
Publicité
