Publicité
Installation with LUAS
Do not install by this method for a child weighing more than
15.9 kilograms (35 pounds).
1. Extend the top tether strap
by lifting on the top tether
adjuster.
2. Unhook the top tether hook
from the back of the child
restraint and place it up and
over the seatback.
3. Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
4. For models WITH storage
pouch only: Open the
storage pouch.
Remove the lower
connectors by pressing
the spring tab, pushing
the connector back while
rotating down and forward
off the anchor point.
5. Extend lower connector
strap to its longest length
by pressing grey button on
adjuster.
6. Recline child restraint to the
appropriate position. Refer
to page 15 to determine
appropriate recline position.
7. Place child restraint
FORWARD-facing on the
vehicle seat so that the
car seat base is flat on the
vehicle seat and is parallel to
vehicle seat.
8. Ensure that no more than
7.5 cm (3 in) of the base
hangs over the front edge
of the vehicle seat.
28
With storage
storage pouch
pouch
(Select Models)
Without
7.5 cm
Publicité
