Publicité
7. Ensure the shoulder part
lays across the center of
the child's chest, above
the child's shoulder and
does not contact the child's
neck (A). The lap part of the
vehicle belt is routed low
across the child's upper
thighs (B).
Before traveling, verify that the:
9 Vehicle belt is not twisted.
9 Shoulder part of vehicle belt is routed through the shoulder belt guide
above the child's shoulder, lies across the center of the child's chest and
does not contact the child's neck.
9 Lap part of the vehicle belt is routed low across the child's upper thighs.
Switching between Harness and Booster Mode
Harness Mode to Booster Mode
NOTE: It is not necessary to use lower anchors and top
tether to position this child restraint in
If using the lower anchors and top tether to position this
child restraint in
follow
BOOSTER
harness. Refer to page 32 Using LUAS in
Mode.
1. Raise the headrest to the
highest position.
2. Loosen the harness. Press
the harness release button
(A) and pull both harness
straps forward (B).
NOTE: Make sure enough
harness adjuster strap is left
hanging from the front of the
seat. Use the inner slot as a
reference point to measure
how much harness strap can
be left hanging from the front
of the seat.
38
BOOSTER
mode, it is recommended to
Mode Installation before storing the
A
B
BOOSTER
mode.
BOOSTER
B
A
Inner Slot
Publicité
